Mitsubishi Electric 800 Series Instruction Manual page 385

 Operation in combination with the self power management function for
the separated converter type
• When the self power management function is used with the separated converter type, the input signal operations are as
follows.
X95
(Converter unit
fault)
OFF OFF
ON ON
OFF ON
*1 When Pr.138="0 (electronic bypass invalid at a fault)", MC2 is OFF. When Pr.138="1 (electronic bypass valid at a fault)", MC2 is ON.
*2 The self power management operation is followed.
*3 MC operation is as shown below.
Notation

ON

OFF
— During inverter operation: MC2-OFF, MC3-ON
During commercial power supply operation: MC2-ON, MC3-OFF
Parameters referred to
Pr.11 DC injection brake operation time
Pr.57 Restart coasting time
Pr.58 Restart cushion time
Pr.79 Operation mode selection
Pr.178 to Pr.189 (Input terminal function selection)
Pr.190 to Pr.196 (Output terminal function selection)
384
5. PARAMETERS
5.11 (A) Application parameters
X96 X94
(Converter unit (Control signal for
fault (E.OHT, main circuit power
E.CPU)) supply MC)
ON
OFF
ON
ON
OFF
MC operation
page 546
page 448
page 448
page 204
*3
MC operation
MC1 MC2 MC3
 
*2

  
- -
*2


*2 *1

-
 
*1
-
page 343
page 297
Converter status
Converter fault
(E.OHT (Pr.248="2"))
Converter fault
(E.OHT (Pr.248="1"), E.CPU)
Converter normal
Converter fault
(other than the circuit failure fault or E.OHT)
(Pr.248="2")
Converter fault
(other than E.OHT or E.CPU)