Mitsubishi Electric 800 Series Instruction Manual page 288

 Current monitor reference (Pr.56)
• Output current, Output current peak value, Motor excitation current and monitor from the terminals CA and AM.
• For the calibration of terminal CA, set the full-scale value of the connected current meter when output current of terminals
CA is 20 mA. Set the current to be indicated as the full scale value on the meter (20 mADC ammeter) connected between
terminals CA and 5. Output current is proportional to the monitored value of output current. (The maximum output current
is 20 mADC.)
• For the calibration of terminal AM, set the full-scale value of the connected current meter when the output voltage of
terminal AM is 10 VDC. Set the current to be indicated as the full scale value on the meter (10 VDC voltmeter) connected
between terminal AM and 5. Output voltage is proportional to the monitored value of output current. (The maximum output
voltage is 10 VDC.)
 Torque monitor reference (Pr.866)
• Set the full scale value when outputting the current monitor from terminal the CA or AM.
• For the calibration of terminal CA, set the full-scale value of the connected torque meter when output current of the terminal
CA is 20 mADC. Set the torque to be indicated as the full scale value on the meter (20 mADC ammeter) connected between
terminals CA and 5. Output current is proportional to the monitored value of torque. (The maximum output voltage is 20
mADC.)
• For the calibration of terminal AM, set the full-scale value of the connected torque meter when the output voltage of terminal
AM is at 10 VDC. Set the torque to be indicated as the full scale value on the meter (10 VDC voltmeter) connected between
terminal AM and 5. Output voltage is proportional to the monitored value of torque. (The maximum output voltage is 10
VDC.)
5. PARAMETERS
5.8 (M) Monitor display and monitor output signal
3
4
5
5
5
6
7
8
9
10
287