Mitsubishi Electric 800 Series Instruction Manual page 39

 Shift and removal of a rear side installation frame
One installation frame is attached to each of the upper and lower parts of the inverter. Change the position of the rear side
installation frame on the upper and lower sides of the inverter to the front side as shown on the right. When changing the
installation frames, make sure that the installation orientation is correct.
Shift
Upper
installation
frame
Lower
installation
Shift
frame
 Installation of the inverter
Push the inverter heat sink portion outside the enclosure and fix the enclosure and inverter with upper and lower installation
frame.
Inside the
enclosure
Inverter/
Converter unit
NOTE
• Having a cooling fan, the cooling section which comes out of the enclosure cannot be used in the environment of water
drops, oil, mist, dust, etc.
• Be careful not to drop screws, dust etc. into the inverter and cooling fan section.
38
2. INSTALLATION AND WIRING
2.3 Installation of the inverter and enclosure design
Enclosure
Exhausted air
There are finger guards behind the enclosure.
Therefore, the thickness of the panel should be
less than 10 mm (∗1) and also do not place
anything around finger guards to avoid contact
with the finger guards.
Installation
frame
∗1
10 mm
Dimension of
Cooling
wind
the outside of
the enclosure
185 mm
Enclosure
Finger guard
140 mm