Mitsubishi Electric 800 Series Instruction Manual page 536

5.12.10 Backup/restore
• The GOT can be used for backing up inverter parameters and the data used in the PLC function of inverter.
• The backup data stored in the GOT can be used to restore the data in the inverter.
Pr. Name
434 Network number (CC-Link IE)
*1
N110
435 Station number (CC-Link IE)
*1
N111
*1 The setting is available in the inverter on which the FR-A8NCE is installed.
GOT2000
 Connected devices
• To enable backup/restore, connect either the general-purpose inverter with the FR-A8NCE to a programmable controller
(master station) via the CC-Link IE Field Network.
NOTE
• The backup/restore function is enabled only when the inverter is connected to a master station programmable controller.
• For details on the connected devices, refer to the GOT2000 Series User's Manual (Monitor).
 Data to be backed up and restored
• The following data can be backed up and restored. The data other than listed below cannot be backed up or restored.
Inverter parameters
Parameters used for activating the PLC function
Programs (including SFCs) used in the PLC function
Global device comment information used in the PLC function
Function block source information
Initial value
0
0
Ethernet
Restoration
MELSEC iQ-R
Item
Setting range
0 to 255 Enter the network number of the inverter.
0 to 255 Enter the station number of the inverter.
CC-Link IE Field Network
Backup
FR-F860 (with the FR-A8NCE installed)
5.12 (N) Operation via communication and its settings
Description
535
5. PARAMETERS
3
4
5
5
5
6
7
8
9
10