Mitsubishi Electric 800 Series Instruction Manual page 4

Injury Prevention
CAUTION
 The voltage applied to each terminal must be the ones specified in the Instruction Manual. Otherwise
an explosion or damage may occur.
 The cables must be connected to the correct terminals. Otherwise an explosion or damage may
occur.
 The polarity (+ and -) must be correct. Otherwise an explosion or damage may occur.
 While power is ON or for some time after power-OFF, do not touch the inverter as it will be extremely
hot. Touching these devices may cause a burn.
Additional Instructions
The following instructions must be also followed. If the product is handled incorrectly, it may cause unexpected fault, an injury,
or an electric shock.
CAUTION
Transportation and installation
 Any person who is opening a package using a sharp object, such as a knife and cutter, must wear
gloves to prevent injuries caused by the edge of the sharp object.
 The product must be transported in correct method that corresponds to the weight. Failure to do so
may lead to injuries.
 Do not stand or rest heavy objects on the product.
 Do not stack the boxes containing inverters higher than the number recommended.
 When carrying the inverter, do not hold it by the front cover; it may fall off or fail.
 During installation, caution must be taken not to drop the inverter as doing so may cause injuries.
 The product must be installed on the surface that withstands the weight of the inverter.
 Do not install the product on a hot surface.
 The mounting orientation of the inverter must be correct.
 The inverter must be installed on a strong surface securely with screws so that it will not drop.
 Do not install or operate the inverter if it is damaged or has parts missing.
 Foreign conductive objects must be prevented from entering the inverter. That includes screws and
metal fragments or other flammable substance such as oil.
 As the inverter is a precision instrument, do not drop or subject it to impact.
 For the FR-F860-00090 or lower, the surrounding air temperature must be -10 to +30°C for the SLD
rating (-10 to +40°C for the LD rating) (non-freezing). Otherwise the inverter may be damaged.
 For the FR-F860-00170 to 01080, the surrounding air temperature must be -10 to +40°C (non-
freezing). Otherwise the inverter may be damaged.
 For the FR-F860-01440 or higher, the surrounding air temperature must be -10 to +40°C for the SLD
rating (-10 to +50°C for the LD rating) (non-freezing). Otherwise the inverter may be damaged.
 The ambient humidity must be 95%RH or less (non-condensing). Otherwise the inverter may be
damaged. (Refer to page 31 for details.)
3