Cooling Unit - Suzuki RA410 Manual

1B-16 AIR CONDITIONING (OPTIONAL)
COOLING UNIT (EVAPORATOR)
4
3
7
5
1
7
1
2
5
4
6
1
5
2
8
3
REMOVAL
1) Disconnect negative (–) cable at battery.
2) Recover refrigerant from refrigeration system by using recovery
and recycling equipment.
3) Disable air bag system, if equipped.
4) Remove heater control cable (1), main harness clamp (2) and
disconnect evaporator thermistor coupler (3).
5) Loosen suction hose (4) & liquid pipe (5) bolt (6).
6) Loosen cooling unit bolt, nut and screw as shown.
7) Remove cooling unit (7).
INSTALLATION
Reverse removal sequence to install cooling unit, noting the follow-
ing points.
If cooling unit or evaporator is replaced, pour 25 cc of refrigerat-
ing oil to compressor suction-side.
Install uniformly the packing (1) to installation hole as shown in
figure.
5
1. Evaporator
2. A/C Evaporator thermistor
(Evaporator temperature sensor)
3. Expansion valve
4. Evaporator case
5. Packing
6. Drain hose
5
7. Air inlet door
6
8. O-ring