Suzuki RA410 Manual page 197

DISASSEMBLY
For Tripod joint type drive shaft (Righ side)
1) Remove differential side boot band, then take out tripod joint
housing (1).
2) Remove grease from shaft and take off snap ring (1) by using
special tool, then pull out spider (2) from shaft.
Special Tool
(A): 09900-06107
CAUTION:
To prevent needle bearing of joint from being de-
greased, do not wash it if it is to be reused.
3) Remove boot band, then pull out differential side boot from
shaft.
4) Undo band of dynamic damper, then pull out damper through
shaft.
5) Undo boot bands of wheel side joint boot, then pull out boot
through shaft.
CAUTION:
Disassembly of wheel side joint is not allowed. If
noise or damage exists in it, replace it as assembly.
Do not disassemble tripod joint spider. If any mal-
condition is found in it, replace it as differential side
joint assembly.
FRONT DRIVE SHAFT 4A-5