Suzuki RA410 Manual page 758

3
1
14) Separate the two banana plugs on the deployment harness.
15) Connect (1) the deployment harness to the power source (12
V vehicle battery) (2) to immediately deploy/activate the air
bag or the pretensioner.
16) Disconnect the deployment harness from the power source
(12 V vehicle battery) (2) and short (4) the two deployment har-
ness leads together by fully seating one banana plug into the
other.
17) Put on a pair of shop gloves to protect your hands from pos-
sible irritation and heat when handling the deployed air bag (in-
flator) module and the activated seat belt pretensioner.
18) Disconnect the deployment harness from the air bag (inflator)
module and the seat belt pretensioner as soon after deploy-
ment/activation as possible.
This will prevent damage to the deployment harness due to
possible contact with the hot air bag (inflator) module and seat
belt pretensioner. The deployment harness are designed to be
reused. They should, however, be inspected for damage after
each deployment/activation and replaced it if necessary.
19) Carefully remove drop cloth (3) from vehicle and clean off any
fragments or discard it entirely.
20) Repeat Steps 2) through 19) to deploy/activate air bag (infla-
tor) modules and seat belt pretensioners which has not been
deployed/activated, if any.
21) In the unlikely event that the air bag (inflator) module and the
seat belt pretensioner proceed immediately with Steps 23)
through 25). If the air bag (inflator) module and the seat belt
pretensioner did deploy/activate, proceed with Steps 22).
22) With air bags deployed and pretensioners activated the ve-
hicle may be scrapped in the same manner as a non-air bag
system equipped vehicle.
23) Remove the undeployed air bag (inflator) module(s) and the
inactivated seat belt pretensioner(s) from the vehicle. For driv-
er air bag (inflator) module refer to SECTION 3C, for passen-
ger air bag (inflator) module refer to ON-VEHICLE SERVICE
in this section, for seat belt pretensioner refer to SECTION 10.
24) [For air bag (inflator) module]
Temporarily store the air bag (inflator) module with its vinyl trim
cover facing up, away from the surface upon which it rests. Re-
fer to SERVICE PRECAUTIONS in this section for details.
[For seat belt pretensioner]
When temporarily strong the seat belt pretensioner, be sure
NOT to face its exhaust hole provided side down. It must face
up. Refer to SERVICE PRECAUTIONS in this section for de-
tails.
25) Contact your local distributor for further assistance.
AIR BAG SYSTEM 10B-63