Suzuki RA410 Manual page 337

6A4-78 ENGINE MECHANICAL
1
4) Install crankshaft to cylinder block.
5) Install lower crankcase to cylinder block.
Tighten crankcase bolts according to next procedure.
(1) Tighten bolts
(2) Tighten bolts
(3) In the same manner as in (1), tighten them to specified
(4) In the same manner as in (2), tighten them to specified
6) Install rear oil seal (3). With special tools, press fit rear oil seal
so that it is flash with cylinder block.
Special Tool
(A): 09911-97020
(B): 09911-97030
2
3
1. Crankshaft side
2. Oil seal side
7) Install flywheel (M/T model) or drive plate (A/T model).
Using special tool, lock flywheel or drive plate, and torque its
bolts to specification.
Special Tool
(A): 09924-17810
Tightening Torque
(a): 70 N
1 10
to to 41 N·m (4.1 kg-m, 29.5 lb-ft) in order
of their numbers.
to to 17 N·m (1.7 kg-m, 12.0 lb-ft) in order
11 20
of their numbers.
torque.
torque.
Tightening Torque
1 to 10 : 58 N·m (5.8 kg-m, 42.0 lb-ft)
to : 24 N·m (2.4 kg-m, 17.5 lb-ft)
11 20
NOTE:
After tightening lower crankcase bolts, check to be sure
that crankshaft rotates smoothly when turned by hand.
.
m (7.0 kg-m, 50.5 lb-ft)