Heater Unit - Suzuki RA410 Manual

5
2
3
INSPECTION
Check blower fan switch for each terminal-to-terminal continuity.
For the detail refer to "WIRING CIRCUIT" earlier in this section.
POSITION

HEATER UNIT

1
REMOVAL
1) Disconnect negative (–) cable at battery.
2) If equipped with air bag system disable air bag system.
Refer to DISABLING AIR BAG SYSTEM in Section 10B.
3) Drain engine coolant and disconnect heater hoses (1) from
heater unit.
4) Remove instrument panel.
Refer to INSTRUMENTPANEL in BODY SERVICE section.
5) Remove bolts (2), nuts (3) and screws (4) as shown.
4
6) Remove heater unit (5).
4
INSTALLATION
Install heater unit by reversing removal procedure, noting the fol-
lowing items.
When installing each part, be careful not to catch any cable or
wiring harness.
Adjust heater control cable (refer to heater control lever assem-
bly in this section).
Fill engine coolant to radiator.
Enable air bag system, if equipped. Refer to "ENABLING AIR
BAG SYSTEM" in Section 10B.
TERMINAL
B
OFF
Lo
M
Hi
HEATER AND VENTILATION 1A-9
E I L M H