Suzuki RA410 Manual page 136

For vehicle without air bag system
For vehicle with air bag system
4
2
INSTALLATION
1) Check that vehicle's front tires are at straight-ahead position
1, "A"
2) For vehicle without air bag system:
3
3) Tighten steering shaft nut (1) to specified torque.
1, (a)
4) For vehicle without air bag system:
and contact coil is centered if equipped with air bag system. Re-
fer to CENTERING CONTACT COIL in this section.
CAUTION:
For vehicle with air bag system:
These two conditions are prerequisite for installation
of steering wheel. If steering wheel has been installed
without these conditions, contact coil will break when
steering wheel is turned.
a) Apply grease to contact plate (1) "A" of steering wheel.
Grease: SUZUKI GREASE CE-T (99000-25290)
b) Install steering wheel onto shaft, aligning them by match
marks.
For vehicle with air bag system:
Install steering wheel to steering shaft with 2 lugs (2) on contact
coil fitted in two grooves (3) in the back of steering wheel and
also aligning marks (4) on steering wheel and steering shaft.
Tightening Torque
(a): 33 N·m (3.3 kg-m, 24.0 lb-ft)
NOTE:
After installing the steering wheel, turn the steering wheel
about 1 full rotation so that the cancel cam pin fits into the
pin hole in the steering wheel and then check the turn sig-
nal lever for proper function.
a) Connect horn connector.
b) Install steering wheel pad.
c) Tighten steering wheel pad screw.
For vehicle with air bag system:
Install driver air bag (inflator) module to steering wheel. Refer
to DRIVER AIR BAG (INFLATOR) MODULE in this section.
STEERING WHEEL AND COLUMN 3C-7