4
1
2
REMOUNTING
NOTE:
3
•
Before installing distributor, check to make sure that its O-
ring (1) is in good condition.
•
If new O-ring (1) is to be installed, apply oil.
1) Install distributor without cap (2) to camshaft.
Fit the dogs of distributor coupling into the slots of camshaft (3),
when installing. The dogs of distributor coupling are offset (4).
Therefore, if the dogs can not be fitted into the slots, turn distrib-
utor shaft by 180° and try again.
2) Lightly install flange bolt and prepare for ignition timing adjust-
ment.
3) Check to make sure that rotor is in good condition.
4) Inspect distributor cap and clean or replace as required.
5) Make sure that distributor cap seal is placed properly and install
cap, and then fasten it with screws.
6) Connect distributor lead coupler.
7) Check and adjust ignition timing as previously outlined.
IGNITION SYSTEM 6F1-13