Suzuki RA410 Manual page 139

3C-10 STEERING WHEEL AND COLUMN
2
3
2
3
**1
*1
"C", (a)
"A", (a)
1
* : Standard screw
** : Tapping screw
"C", (a)
"B", (a)
1
3) Install combination switch/contact coil and combination switch
assembly (3) to steering column.
NOTE:
For vehicle with air bag system
New contact coil and combination switch assembly is sup-
plied with contact coil set and held at its center position
with a lock pin (1) and seal (2). Remove this lock pin after
installing contact coil and combination switch assembly to
steering column.
CAUTION:
When installing lower cover (3) and upper cover (2),
be careful so that combination switch/contact coil
and combination switch lead wire is not caught be-
tween covers.
4) Install steering column upper cover (2) and lower cover (3), and
then tighten steering column cover screws (1).
5) Tighten steering column mounting nuts ("A", "B", "C") by hand
and then tighten them to specified torque in the order
("A"–"B"–"C") in the figure.
Tightening Torque
(a): 14 N·m (1.4 kg-m, 10.5 lb-ft)
6) Install steering column hole cover (1).
7) Install steering wheel to steering column. Refer to STEERING
WHEEL in this section.