Suzuki RA410 Manual page 279

6A4-20 ENGINE MECHANICAL
3
INSTALLATION
1) Apply sealant to oil pan mating surface continuously as shown
in figure.
"A" Sealant: 99000-31150
2) Install oil pump strainer (1) and oil pan (2).
3
Install seal (3) to oil pump strainer in the position as shown in
figure.
Install strainer to cylinder block, then tighten strainer bolt to spe-
cified torque.
Tightening Torque
(a): 11 N
After fitting oil pan to cylinder block, run in securing bolts and
start tightening at the center: move wrench outward, tightening
one bolt at a time.
Tighten bolts to specified torque.
Tightening Torque
(b): 11 N
2
3) Install gasket and drain plug (1) to oil pan.
Tighten drain plug (1) to specified torque.
Tightening Torque
(a): 44 N
1, (a)
4) Install clutch (torque converter) housing lower plate.
.
m (1.1 kg-m, 8.0 lb-ft)
.
m (1.1 kg-m, 8.0 lb-ft)
.
m (4.4 kg-m, 31.8 lb-ft)