Suzuki RA410 Manual page 734

DTC 61 – "AIR BAG" WARNING LAMP CIRCUIT FAILURE
B/Y
1. From main fuse
2. Ignition switch
3. "IG METER" fuse in fuse box
4. "AIR BAG" warning lamp in combination meter
CAUTION:
Be sure to perform AIR BAG DIAGNOSTIC SYSTEM CHECK before starting diagnosis according
to flow table.
When measurement of resistance or voltage is required in this table, use a specified digital multi-
meter (Refer to SPECIAL TOOLS in this section.) along with a correct terminal adapter from special
tool (Connector test adapter kit).
When a check for proper connection is required, refer to INTERMITTENT AND POOR CONNEC-
TIONS in this section.
If there is open circuit in the air bag wire harness, connector or terminal is found damaged, replace
the wire harness, connector and terminal as an assembly.
DTC WILL SET WHEN:
The voltage at the "AIR BAG" warning lamp circuit terminal "A2" does not match the commanded state of the warn-
ing lamp driver for specified time.
TABLE TEST DESCRIPTION:
STEP 1: This test rechecks "AIR BAG" warning lamp operation.
STEP 2: This test rechecks whether an abnormality is in SDM.
DIAGNOSTIC FLOW TABLE:
STEP
1 1) This DTC is set when there is a trouble in
"AIR BAG" warning lamp circuit. Failure
to properly perform AIR BAG DIAGNOS-
TIC SYSTEM CHECK may also result in
misdiagnosis. Therefore, check "AIR
BAG" warning lamp circuit again accord-
ing to AIR BAG DIAGNOSTIC SYSTEM
CHECK.
2) Is "AIR BAG" warning lamp circuit in
good condition?
B/Y
:Air bag harness
5. "AIR BAG" fuse in fuse box
6. Connection detection pin
7. SDM
8. To DLC
ACTION
Y/B
R
BI
9. To ECM (or PCM) and ABS control module (if equipped)
10. "AIR BAG" monitor coupler
11. Ground for air bag system
YES
Go to Step 2 on next
page.
AIR BAG SYSTEM 10B-39
Y/B
R
A4
BI
NO
Repair "AIR BAG" warning
lamp circuit.