Suzuki RA410 Manual page 364

6C-10 ENGINE FUEL
2
[1]
2, "A"
2, "A"
1
[2]
DISASSEMBLY/REASSEMBLY
CAUTION:
While removing fuel level gauge, do not contact resis-
tor plate [1] or deform arm [2]. It may cause fuel level
gauge to fail.
When removing grommet from fuel tube or bracket
sub assembly, be very careful not to cause damage to
grommet installed section (sealed section in bore).
Should it be damaged, replace it with new one, or fuel
will leak from that part.
NOTE
When removing fuel level sensor (1), press snap-fit part (2) and
slide it in the arrow direction as shown in the figure.
When installing fuel level sensor to housing, fit fuel level sensor
securely.
INSTALLATION
1) Clean mating surfaces of fuel pump assembly (1) and fuel tank.
2) Install new gasket (2) and plate (3) to fuel pump assembly then
install fuel pump assembly to fuel tank.
"A": Apply oil
1. Bracket sub assembly
(including fuel filter)
2. Grommet
3. Tube
4. Housing
5. Lead wire
6. Fuel level sensor
(Fuel sender gauge)
7. Fuel pump
8. Cushion
9. Bracket
10. Spacer