Suzuki RA410 Manual page 463

3
1
2
2
1
3
2
1
3
2
1
3) Loosen 2 bolts and 2 screws to remove rear bracket.
4) Separate front housing (1) and armature (2) from yoke (3).
5) Draw brushes (1) out of holder (2).
6) Draw stop ring (1) toward clutch side and remove snap ring (2)
and slide off over-running clutch (3).
1
INSPECTION
ARMATURE
Inspect commutator (1) for dirt or burn. Correct with sandpaper or
lathe, if necessary.
Check commutator (1) for uneven wear with armature supported
on V-blocks (2). If deflection of dial gauge (3) pointer exceeds limit,
repair or replace.
NOTE:
Below specification presupposes that armature is free from
bend. Bent shaft must be replaced.
Commutator out of round
Standard: 0.05 mm (0.0019 in.) or less
2
Limit : 0.4 mm (0.015 in.)
CRANKING SYSTEM 6G-7