Suzuki RA410 Manual page 542

LINE PRESSURE TEST
This test is to check fluid pressure system for operation by measur-
ing fluid pressure in fluid pressure line. Make sure to perform this
test only when transmission fluid is at normal operating tempera-
ture.
NOTE:
(A)
1) With engine at stop, remove plug and connect fluid pressure
2) Install tachometer.
3) Apply parking brake and block vehicle wheels.
4) With selector lever shifted to P range, start engine.
5) Depress brake pedal fully.
6) Shift select lever to D range and check fluid pressure with engine
7) Repeat the same check as in step 6) with selector lever shifted
8) If line pressure is within respective specification in table below,
Make sure that transmission fluid level is between FULL and
LOW marks on fluid level gauge at normal operating temper-
ature of fluid. (Refer to "Fluid Level" in this section.)
Check that transmission is free from fluid leakage.
gauge to plug hole.
Special Tool
(A): 09925-37810
running at idling speed and at stall speed respectively.
to R range.
CAUTION:
Do not run engine at stall more than 5 seconds continu-
ously, for fluid temperature may rise excessively high.
fluid pressure system is in good condition.
Engine speed Engine speed
Idling speed
Stall speed
(2400 –2800 r/min)
AUTOMATIC TRANSMISSION 7B-15
Line pressure
D range
2
4.2 – 4.7 kg/cm 8.8 – 9.8 kg/cm
(60 – 67 psi) (125 – 139 psi)
2
6.7 – 7.6 kg/cm 13.9 – 15.7 kg/cm
(95 – 107 psi) (197 – 223 psi)
R range
2
2