Ignition Switch; Combination Meter - Suzuki RA410 Manual

8-16 BODY ELECTRICAL SYSTEM
2
3

IGNITION SWITCH

REMOVAL AND INSTALLATION
Refer to COMBINATION SWITCH, STEERING COLUMN AND
STEERING SHAFT LOWER JOINT in Section 3C.
INSPECTION
1) Disconnect negative cable (–) at battery.
2) Remove steering column upper and lower cover.
3) Disconnect wiring main harness coupler from ignition switch.
4) Check continuity at each switch position by using circuit tester.
If any continuity is not obtained, replace main switch.
key
OUT
IN IN
ACC : Accessory

COMBINATION METER

REMOVAL
1) Disconnect negative cable (–) at battery.
2) Loosen steering column mounting screws and nuts. (Refer to
Section 3C.)
3) Remove ashtray cover, cigarette lighter socket assembly and
then remove instrument center garnish.
4) Remove cup holder and remove meter cluster panel (1). Make
1
sure to disconnect all couplers of switches.
5) Disconnect couplers from combination meter.
Remove combination meter (2).
INSTALLATION
Reverse removal procedure for installation.
INSPECTION
Check printed plate (3) visually for scratch, crack and discolor-
ation. If any of such faulty conditions is found, replace the printed
plate.
Terminal
+B1 +B2 +ACC IG1
Position
LOCK LOCK
ACC
ON ON
START START
IG2 ST K1 K2