Suzuki RA410 Manual page 419

6E1-54 ENGINE AND EMISSION CONTROL SYSTEM
TERMINAL ARRANGEMENT OF ECM/PCM
CONNECTOR (VIEWED FROM HARNESS SIDE)
A26
TP SENSOR
ADJUSTMENT
1) Warm up engine to normal operating temperature.
2) Loosen TP sensor screws.
3) Remove ECM/PCM as previously outlined and with connectors
connected to ECM/PCM, connect digital type voltmeter be-
tween "C6" and "A26" terminal.
C6
4) Turn TP sensor (1) clockwise or counterclockwise and fix TP
sensor at a position where voltage as specified below is ob-
tained.
TP sensor output voltage when throttle is completely
closed: 0.50
5) Tighten TP sensor screw to specified torque.
Tightening Torque
(a): 2.5 N·m (0.25 kg-m, 1.8 lb-ft)
6) Check to make sure that TP sensor voltage is as shown below
when throttle is fully open.
TP sensor output voltage when throttle is completely
opened: 4.2
7) Turn ignition switch to OFF position and disconnect negative
cable at battery for one minute or more.
8) Connect battery cable to battery terminal.
9) Install ECM/PCM as previously outlined.
0.15 V
0.5 V