Suzuki RA410 Manual page 522

4
3
6
4
1
5
(2)
3, (a)
12) Put a bearing set shim (1) on bearing cup (2) provisionally,
place straight edge (3) over it and compress it by hand through
straight edge, and then measure ™a∫ (Clearance between case
3
surface (4) and straight edge) using feeler gauge (5).
Clearance ™a∫: 0.08 ± 0.12 mm (0.0032 ± 0.0047 in.)
(Shim protrusion)
1
13) By repeating above step, select a suitable shim which adjusts
™a∫
clearance ™a∫ to specification and put it on bearing cup.
NOTE:
Insert 0.1 mm (0.004 in.) feeler to know whether or not a
shim fulfills specification quickly
2
Available
thickness
14) Place left case plate (1) inserting its end in groove of 5th & re-
verse gear shift guide shaft (2) and then tighten it with new screws.
NOTE:
After tightening screws, make sure that counter shaft (4)
(4)
can be rotated by hand feeling some load.
Tightening Torque
(a): 9 N
(1)
CAUTION:
Do not reuse left case plate screws. Be sure to use
the new screws with pre-coat adhesive. Otherwise,
screw may loosen.
0.4, 0.45, 0.5, 0.55, 0.6, 0.65, 0.7, 0.75, 0.8,
0.85, 0.9, 0.95, 1.0, 1.05, 1.1 and 1.15 mm
shim
(0.015, 0.017, 0.019, 0.021, 0.023, 0.025,
0.027, 0.029, 0.031, 0.033, 0.035, 0.037,
0.039, 0.041, 0.043 and 0.045 in.)
m (0.9 kg-m, 6.5 lb-ft)
•
MANUAL TRANSMISSION 7A-29
.