Suzuki RA410 Manual page 517

7A-24 MANUAL TRANSMISSION
(A)
4
5
3
2
2
5
7
1
2
1. Reverse gear shift arm spring
2. Steel ball
3. Reverse gear shift arm
4. Spring pin
5. 5th & reverse gear shift shaft
6. 5th & reverse gear shift yoke
7. 5th & reverse gear shift guide shaft
A: Face pin slit toward front
6
4
7
6
A
4
3
3
2
HIGH SPEED AND LOW SPEED GEAR SHIFT SHAFTS
Inspection
1) Using feeler gauge, check clearance between fork (1) and
sleeve (2) and replace those parts if it exceeds limit of 1.0 mm
(0.039 in.).
NOTE:
For correct judgement of parts replacement, carefully in-
spect contact position of fork and sleeve.
Clearance "a": Service limit 1.0 mm (0.039 in.)
2) Insert each gear shift shaft into case and check that it moves
smoothly. If it doesn't, correct using oilstone, reamer or the like.
5TH & REVERSE GEAR SHIFTER
1) Disassemble component parts using special tool and hammer.
Special Tool
(A): 09922-85811 (4.5 mm)
2) Replace or correct parts as required and assemble shafts mak-
ing sure that component parts are in proper order as shown left.
NOTE:
Distinguish reverse gear shift arm spring (1) from locat-
ing springs.
Install 2 steel balls (2) in reverse gear shift arm (3) with-
out fail.
Drive in spring pin (4) for reverse shift arm facing slit A
toward front.