Suzuki RA410 Manual page 692

10-6 RESTRAINT SYSTEM
1
INSPECTION
Seat belts and attaching parts can affect the vital components and
systems of a vehicle.
Therefore, they should be inspected carefully and replaced with
genuine parts only.
Seat belt
Its webbing or strap should be free from damage.
Retractor assembly
It should lock webbing when pulled quickly.
The front seat belt retractor assembly (1) should pass the above
inspection and should lock webbing even when tilted (approx.
15 ) toward the fore and aft or right and left directions.
Anchor bolt
Anchor bolts should be torqued to specification.
Belt latch
It should be secure when latched.
INSTALLATION
Install in reverse order of removal, noting the following.
Seat belt anchor bolts should have an unified fine thread
(7/16–20 UNF). Under no circumstances should any different
sized or metric screw threads be used.
Be sure to tighten seat belt anchor bolts to specified torque.
Tightening Torque
(a): 35 N·m (3.5 kg-m, 25.5 lb-ft)
(b): 5.5 N·m (0.55 kg-m, 4.0 lb-ft)
Be sure to tighten retractor assembly mounting bolt and screw
in the order ("A", "B") as shown in the figure.
Tightening Torque
(a): 35 N·m (3.5 kg-m, 25.5 lb-ft)