Suzuki RA410 Manual page 451

6F1-8 IGNITION SYSTEM
1
2
1
3
NOISE SUPPRESSOR
REMOVAL
1) Remove air cleaner assembly.
2) Unwrap tape from nose suppressor.
3) Disconnect coupler of noise suppressor (1).
4) Remove noise suppressor.
2. Starting
motor
INSPECTION
Using ohmmeter (1), check to be sure that capasitor (Condenser)
in noise suppressor (2) is not conductive.
If check result is not satisfactory, replace noise suppressor (2).
INSTALLATION
2
Reverse removal procedure for installation.
IGNITER
2
Before this inspection, prepare two new 1.5V batteries, one 12V
1
3.4W light bulb and one 12V battery (fully charged).
REMOVAL
1) Remove ignition coil/igniter assembly (1) from vehicle.
2) Remove igniter (2) from bracket.
INSPECTION
1) Arrange 2 new 1.5V batteries (1) in series (check that total volt-
2) Connect test bulb (12 V 3.4 W) (2) between "IG COIL" terminal
5
1
3) Connect positive (+) side of "two 1.5V batteries in series" (1) to
4
INSTALLATION
1) Reverse removal procedure for installation.
2
age is about 3.0V).
of igniter (3) and battery positive (+) terminal, then connect bat-
tery negative (–) terminal to "G" terminal (4).
Check that the test bulb (1) DOES NOT illuminate.
"IGT" terminal (5) and negative (–) side to "G" terminal of igniter
(4).
Check that the test bulb DOES illuminate.
If inspection result is not satisfactory, replace igniter.