Suzuki RA410 Manual page 321

6A4-62 ENGINE MECHANICAL
Crankshaft
pulley side
1
(a)
3) When installing piston and connecting rod assembly into cylin-
1. Crankshaft pulley side
2. Flywheel side
4) Install piston and connecting rod assembly into cylinder bore.
5) Install bearing cap (1):
2
6) Reverse removal procedure for installation, as previously out-
7) Check to ensure that all removed parts are back in place. Rein-
8) Install engine assembly to vehicle as previously outlined.
der bore, point arrow mark on piston head to crankshaft pulley
side.
Use special tool (Piston ring compressor) to compress rings.
Guide connecting rod into place on crankshaft.
Using a hammer handle, tap piston head to install piston into
bore. Hold ring compressor firmly against cylinder block until all
piston rings have entered cylinder bore.
Special Tool
(A): 09916-77310
Point arrow mark on cap (2) to crankshaft pulley side.
Tighten cap nuts to specification.
Tightening Torque
.
(a): 33 N m (3.3 kg-m, 24.0 lb-ft)
lined.
stall any necessary parts which have not been reinstalled.