Suzuki RA410 Manual page 651

2
"a"
"b"
"c"
5) Install new molding (1) to glass (2).
6) Clean glass (2) surface to be adhered to body with clean cloth.
If cleaning solvent is used, let it dry for more than 10 minutes.
Cleaning Area
Distance from the edge of glass or molding
"a": 30 – 50 mm (1.18 – 1.97 in.)
7) Install new spacer (1) to glass (2) as shown in figure.
8) Using new brush, apply sufficient amount of primer for glass
along glass surface to be adhered to body.
NOTE:
Be sure to refer to maker's instruction for proper handling
and drying time.
Do not apply primer on outside of ceramic coated surface.
Do not touch primer coated surface.
Width "a": 18 mm (0.71 in.)
"b": 13 mm (0.51 in.)
"c": 22 mm (0.87 in.)
BODY SERVICE 9-9