Suzuki RA410 Manual page 592

2
1
7
5
6
4
2
1
2
4
3
1
8) After inspection, install cushion plates (1), separator plates (2)
3
9) Attach bearing to rear internal gear hub assembly (1) and set
10) Install cushion plates (1), separator plates (2) and friction
3
11) Assemble rear planetary carrier, one-way clutch (1), one-way
1
2
12) Install parking pawl (1), spring (2), spring collar (3) and shaft (4)
5
and friction plates (3) in that order.
CAUTION:
Install retaining plate with its inner protrusion side fac-
ing down.
them in case.
plates (3) as shown in left figure, and then retaining plate (4),
one-way clutch outer race (5), separator plate (6) and snap ring
(7) in that order.
clutch outer race and one-way clutch retaining plate and then
set them in case.
CAUTION:
Install them into case so that groove (2) side of one-
way clutch faces up.
Check that rear planetary carrier turns smoothly when
turned clockwise and locks when turned counter-
clockwise.
to case.
Install parking lock support (5).
AUTOMATIC TRANSMISSION 7B-65