Suzuki RA410 Manual page 458

6G-2 CRANKING SYSTEM
CRANKING CIRCUIT
The cranking circuit consists of the battery, starting motor, ignition switch, and related electrical wiring. These com-
ponents are connected electrically as shown in figure below. Only the starting motor will be covered in this section.
STARTING MOTOR CIRCUIT
In the circuit shown in figure below, the magnetic switch coils are magnetized when the ignition switch is closed.
The resulting plunger and pinion drive lever movement causes the pinion to engage the engine flywheel gear and
the magnetic switch main contacts to close, and cranking takes place.
When the engine starts, the pinion over-running clutch protects the armature from excessive speed until the switch
is opened, at which time the return spring causes the pinion to disengage.
Pinion & Over-running
clutch
GENERAL DESCRIPTION
Park/Newtral position
switch in transmission
range sensor for A/T