Suzuki RA410 Manual page 159

2
1
1
1, (a)
INSTALLATION
For installation, reverse removal procedure, observing following
instructions.
Install stabilizer bar (2) so that paint mark (1) on it comes to the
right side of vehicle.
There is a paint mark (1) on the front of stabilizer bar. Install sta-
bilizer bar mount bracket to outside of stabilizer bar at that mark.
Install mount bracket (1) so that its oblong hole side (2) comes
to the rear.
Tighten stabilizer bar mounting bracket bolts to specified torque.
Tightening torque for stabilizer bar mounting bracket bolt:
45 N·m (4.5 kg-m, 32.5 lb-ft)
Tighten new stabilizer bar nut (1) to specified torque.
Tightening Torque
(a): 68 N·m (6.8 kg-m, 49.5 lb-ft)
FRONT SUSPENSION 3D-11