Suzuki RA410 Manual page 602

1
48) Install the following parts and tighten its bolt or nut to specified
torque.
Shift range switch
Fluid filler tube
Cooler hose joint
Select cable bracket
Mount bracket and mount
49) Install torque converter to input shaft.
(1) Install torque converter, using care not to damage seal of oil
pump.
Using 12 mm bolt (1) as shown in figure will facilitate instal-
lation.
(2) After installing torque converter, check to make sure that dis-
tance "j" is within specification.
1
Distance "j": More than 23.7 mm (0.93 in)
(3) Check torque converter for smooth rotation.
CAUTION:
Before installing converter, make sure that its
pump hub portion is free from nicks, burrs or dam-
age which may cause oil seal to leak.
Be very careful not to drop converter on oil pump
gear. Damage in gear, should it occur, may cause
a critical trouble.
AUTOMATIC TRANSMISSION 7B-75