Suzuki RA410 Manual page 586

LEFT SIDE
1
2
RIGHT SIDE
2
3) Remove L bearing by using puller while supporting its center
4) Support differential case (1) with soft jawed vise and remove fi-
5) Using special tool and hammer, drive out differential side pinion
ASSEMBLY
(D)
Asselmbly in reverse order of disassembly, nothing the following.
Assembly differntial gear (2) and measure thrust play of differential
gear as follows.
Differential gear thrust play:
(E)
Available thrust washer thickness:
1. Screwdriver
(D)
Special Tool
(D): 09900-20606
(E)
(E): 09900-20701
shaft.
nal gear bolts then take out final gear.
shaft pin and then disassemble component parts.
Special Tool
(C): 09922-85811
0.03 – 0.04 mm (0.0012 – 0.015 in)
0.90, 0.95, 1.00, 1.05, 1.10, 1.15, 1.20 mm (0.035, 0.037, 0.039,
0.041, 0.043, 0.045, 0.047 in.)
Install exciter ring (2), directing as shown.
Press-fit bearings (1) by using special tool and copper hammer.
Special Tool
(F): 09951-76010
(G): 09951-16060
AUTOMATIC TRANSMISSION 7B-59