Suzuki RA410 Manual page 657

BACK DOOR GLASS
REMOVAL
1) Remove rear wiper arm.
2) Disconnect rear defogger coupler.
3) As back door glass (2) is fixed by means of back door window
weatherstrip (1), remove glass (2) and weatherstrip (1) together
by removing end of weatherstrip (1) little by little while pushing
the entire glass (2) from inside toward outside as shown in fig-
ure.
NOTE:
Do not apply an excessive force to glass locally.
INSTALLATION
1) Install weatherstrip (1) to glass (2).
2) Pass string through outer groove of weatherstrip (1) (groove
where back door panel (3) fits in) so that weatherstrip (1) can
be installed to back door.
3) Apply soap water to outer edge of back door panel (3) and install
glass (2) and weatherstrip (1) together to back door by pulling
the string little by little.
4) Connect rear defogger coupler.
5) Install rear wiper arm.
6) Check for water leakage by running water from hose over win-
dow. If leakage is found, complete the installation of leaky point.
If water still leaks even after that, remove glass and start instal-
lation procedure all over again.
NOTE:
Do not use high pressure water.
BODY SERVICE 9-15