Suzuki RA410 Manual page 218

5-14 BRAKES
1
2
CALIPER ASSEMBLY
REMOVAL
1) Loosen wheel nuts and with vehicle lifted up, remove wheels.
2) Remove flexible hose bolt (1) and washer.
CAUTION:
Keep end or disconnected hose in a container (2) so that
brake fluid will not get on vehicle body or floor.
3) Remove caliper pin bolt and remove caliper from caliper carrier.
DISASSEMBLY
CAUTION:
Clean around caliper with brake fluid before disassem-
bly.
1) Remove piston with air blown into flexible hose bolt installation
hole.
WARNING:
Do not apply too highly compressed air which will
cause piston to jump out of cylinder. It should be tak-
en out gradually with moderately compressed air. Do
not place your fingers in front of piston when using
compressed air.