Suzuki RA410 Manual page 106

3B-14 MANUAL RACK AND PINION
Install tie rod ends (1) to knuckles (2) (R & L). Tighten each castle
1
nut (3) until holes for split pin align but within specified torque and
2
then bend new split pin (4) as shown.
Tightening Torque
(a): 43 N·m (4.3 kg-m, 31.5 lb-ft)
NOTE:
Removed split pin (4) should be replaced with new one.
3, (a)
4
Tighten tie rod end lock nut (1) to specified torque.
1, (a)
Tightening Torque
(a): 45 N·m (4.5 kg-m, 32.5 lb-ft)
Tighten wheel nut (1) to specified torque.
1, (a)
Tightening Torque
(a): 85 N·m (8.5 kg-m, 61.5 lb-ft)
After completion of installation, check wheel alignment.
Check toe setting. Adjust as required. (Refer to Section 3A
FRONT END ALIGNMENT.)