Suzuki RA410 Manual page 652

9-10 BODY SERVICE
"b"
2
"b"
2
"a"
1
"c"
2
"a"
1
"d"
9) Apply adhesive (1) referring to figure at the left.
NOTE:
Start from bottom side of glass (2).
Be careful not to damage primer.
Height of adhesive (1) applied to lower side should be high-
er than that of other three sides.
Upper, right and left sides
Width "a" : Approx. 7 mm (0.28 in.)
Height "b" : Approx. 15 mm (0.59 in.)
Distance "c" : Approx. 10.5 mm (0.41 in.)
"d" : Approx. 17 mm (0.67 in.)
Press glass (2) against body quickly after adhesive (1) is ap-
plied.
Use of rubber sucker grip is helpful to hold and carry glass
(2) after adhesive is applied.
Perform steps 9) to 10) within 10 min. to ensure sufficient
adhesion.
Be sure to refer to adhesive (1) maker's instruction for prop-
er handling and drying time.
10) Holding rubber sucker grips (1), place glass onto body by
aligning mating marks marked in step 3) and press it.