Suzuki RA410 Manual page 716

DIAGNOSTIC FLOW TABLE:
DTC 15 – PASSENGER AIR BAG INITIATOR CIRCUIT RESISTANCE HIGH
STEP
1 1) With ignition switch OFF, disconnect passen-
ger air bag (inflator) module ("D") connector
behind the glove box.
2) Check proper connection to passenger air
bag (inflator) module at terminals in "D" con-
nector.
3) If OK then connect Special Tool (B) to pas-
senger air bag (inflator) module ("D") con-
nector disconnected at the step 1).
4) With ignition switch ON, is DTC 15 current?
2 1) With ignition switch OFF, disconnect SDM
("A") connector.
2) Check proper connection to SDM at termi-
nals "A7" and "A8".
3) If OK then measure resistance between "A7"
and "A8" terminals with connected Special
Tool (B).
4) Is resistance 2.9
Fig. for Step 1 and 2
Special Tool
(A): 09932-76010
(B): 09932-75010
NOTE:
Upon completion of inspection and repair work, perform following items.
1) Reconnect all air bag system components, ensure all components are properly mounted.
2) Clear diagnostic trouble codes (Refer to DIAGNOSTIC TROUBLE CODE (DTC) CLEARANCE), if any.
3) Repeat AIR BAG DIAGNOSTIC SYSTEM CHECK to confirm that the trouble has been corrected.
ACTION
or less?
YES
Go to Step 2.
Substitute a known-good
SDM and recheck.
Fig. for Step 2
AIR BAG SYSTEM 10B-21
NO
1) Ignition switch OFF.
2) Replace passenger
air bag (inflator) mod-
ule (Refer to PAS-
SENGER AIR BAG
(INFLATOR) MOD-
ULE in this section).
Repair high resistance or
open in "Bl/R" or "Y/R"
wire circuit.