Suzuki RA410 Manual page 596

1. Snap ring plier
1
2
25) Drive in differential side oil seal.
26) Install drain plug.
27) Apply A/T fluid to O-ring of band servo and install snap ring by
28) Assemble direct clutch assembly (1) and forward clutch and in-
29) Install needle bearing (1) to front side of front internal gear (2)
2
3
30) Install front planetary carrier (1) to front internal gear hub (2)
1
3
Tightening torque for drain plug
.
40 N m (4.0 kg-m, 29 lb-ft)
using special tools.
Special Tool
(D) : 09916-14510
(E) : 09916-48210
put shaft (2).
and race incorporated type bearing (3) to rear side.
NOTE:
To facilitate installation of bearing, apply grease (SUZUKI
SUPER GREASE C: 99000-25030) to internal gear side of
bearing.
and then install them to forward clutch (3).
AUTOMATIC TRANSMISSION 7B-69