Suzuki RA410 Manual page 570

4
1. Transmission case
2
1
1
33) Using special tool, push down spring retainer (2) and remove
snap ring (3).
CAUTION:
With bearing inner race remover shaft fixed, tighten
on nut side.
Do not push down return spring (4) more than neces-
sary.
Special Tool
(E) : 09926-98320
(F) : 09941-84510
(G): 09926-98370
34) Remove 1st-reverse brake piston.
NOTE:
Blow air into oil hole (1) gradually while holding piston by
hand so that it does not tilt.
35) Remove nut from manual shaft (1) and then remove manual
plate.
36) After removing manual shaft lock bolt (1), move shaft upward,
remove O-ring and pull up manual shaft (2).
AUTOMATIC TRANSMISSION 7B-43