Suzuki RA410 Manual page 75

1. Armature plate
2. Screw
3. Washer
INSTALLATION
1) Install magnet clutch coil.
Protrusion on under side of coil ring must match hole in com-
pressor assembly to prevent movement ant correctly locate
lead wire.
2) Using special tool (C), install snap ring as shown.
Special Tool
1. Snap ring
2. Clutch coil
(C): 09900-06107
2. Compressor
3) Clamp covering portion of lead wire.
assembly
4) Install magnet clutch.
(1) Set magnet clutch squarely over clutch installation boss.
(2) Place special tool (D) onto clutch bearing.
Ensure that edge rests only on inner race of bearing.
(3) Install snap ring.
Special Tool
(D): 09991-06010
5) Adjust clearance, between armature plate and magnet clutch
by putting shim on compressor shaft.
Standard clearance "a": 0.3 – 0.6 mm (0.012 – 0.024 in.)
6) Tighten new armature plate nut as specified below.
Tightening Torque
(a): 14 N·m (1.4 kg-m, 10.5 lb-ft)
Special Tool
(A): 09991-06020
CAUTION:
Be careful not to scratch bearing seal.
AIR CONDITIONING (OPTIONAL) 1B-23