Suzuki RA410 Manual page 453

6F1-10 IGNITION SYSTEM
1
2
2. Crankshaft pulley
3. Water pump pulley
1
D
E
1
3
CMP Sensor Resistance
1) Disconnect distributor lead wire coupler (1).
2) Measure resistance of CMP sensor by using ohmmeter.
CMPsensor resistance: Approx. 735
3) If resistance is out of specification, replace CMP sensor as fol-
lows.
4) Remove distributor cap and rotor.
5) Remove CMP sensor securing screws.
6) Replace CMP sensor.
7) Adjust signal rotor air gap to specifications as previously out-
lined.
8) Install rotor, distributor cap seal and cap.
IGNITION TIMING
NOTE:
Before starting engine, place transmission gear shift lever in
"Neutral" (shift select lever to "P" range for A/T model), and
set parking brake.
INSPECTION AND ADJUSTMENT
1) Set timing light to No. 1 high-tension cord.
2) Fix ignition timing to initial one as follows:
a) Connect D and E terminals of monitor coupler (1) by using
service wire so that ignition timing is fixed on initial one.
3) Using timing light (1), check that timing is within specification.
Initial ignition timing (Test switch terminal grounded):
5 1 BTDC (at idle speed)
Ignition order 1-3-4-2
(at 20 C/68 F)