Suzuki RA410 Manual page 655

1
2
1
1
2
324.5 mm (12.8 in.)
4) Remove door trim (1) with inside weatherstrip.
With inside handle bezel (2) tilted as shown in figure, turn door
trim (1) 90 clockwise to remove it. And disconnect power win-
dow switch lead wire (if equipped).
5) Remove door inside pull handle bracket (1).
1
6) Remove door sealing cover.
7) Remove outer weatherstrip (1).
8) Detach rear part of glass run (1) from sash (2) and remove sash
3
(2) by removing three screws (3).
9) Remove rear door glass.
3
INSTALLATION
Reverse removal procedure to install door glass noting the follow-
ing points:
Glass fitted position of bottom channel (1) is as shown in figure.
1
CAUTION:
Using a tape-wrapped putty knife (or tape-wrapped
screwdriver), pry off weatherstrip. Use of an un-
wrapped tool will cause damage to painting.
BODY SERVICE 9-13