Configuring Clock Synchronization - Huawei SmartAX MA5603T Configuration Manual

Access module
Hide thumbs Also See for SmartAX MA5603T:
Table of Contents

Advertisement

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
------------------------------------------------------------------------------
0
------------------------------------------------------------------------------
Total: 1

14.4.5.5 Configuring Clock Synchronization

In this scenario, network-wide clock synchronization is implemented through synchronous
Ethernet clocks.
Prerequisites
l
l
l
Data Plan
Item
Ethernet upstream
board
Procedure
l
Issue 01 (2014-04-30)
0/1 /0
0
MPLS e024-7f98-a21b
The clock daughter board CKMC/CKMD of the SCU control board is in position.
The Ethernet upstream board is the GICK/GSCA (GE port) or X2CS/SPUF (10GE port)
board.
The upstream MAN PSN of the OLT supports Synchronous Ethernet.
Data
Port: 0/19/0
NOTE
The SPUF board exclusively occupies a service slot. This topic uses the GIU
upstream board as an example.
Configure the OLT-side clock.
1.
Configure a system clock source.
Use the Ethernet line clock input from GIU port 0/19/0 as the system clock. Set the
index of the system clock to 0 and priority to 0 (highest priority).
huawei(config)#clock source 0 0/19/0
huawei(config)#clock priority system 0
2.
Query the configurations and status of the system clock source.
Run the display clock source system command to query the configurations and status
of the clock source. Ensure that the configurations of the system clock source are
correct and the status of the system clock source is Normal.
huawei(config)#display clock source system
-------------------------------------------------------------------------
-----
Index
Board
Selected
-------------------------------------------------------------------------
-----
0
H801GICK 0/19/0
YES
-------------------------------------------------------------------------
-----
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
14 FTTM Configuration (Base Station Access)
Source
Clk-type
State
ETH
Normal
-
9343
8192
Priority QL
0
---
TOE
1473

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Smartax ma5600tSmartax ma5608t

Table of Contents