Release Bearing; Disassembly/F Nspection - Honda Prelude 1993 Service Manual

Release Bearing
Disassembly/lnspection
Remove the boot trom the clutch housing.
Remove the release fork from the clutch housing by
squeezing the release fork set spring with pliers.
Remove the release bearing.
RELEASE FORK SET
SPRING
Check the release b€aring for play by spinning it by
h a n d .
CAUTION: Tho reloass besring is packed with
groas€. Do not wa3h it in solvsnt.
lf there is excessive play, replace the release bear
ing with a new one.
RELEASE FOBK
lnstallation
N O T E : U s e o n l y S u p e r H i g h T e m p U r e a G r e a s e ( P / N
08798 -
9002).
Install the release fork set spring on the release tork.
RELEASE FORK
RELEASE FORK SET SPBING
With the release fork slid between the release bear-
ing pawls, install the release bearing on the main-
shaft while insening the release fork through the
hole in clutch housing.
Align the detent of the release fork with tlle release
f o r k b o l t , t h e n p r e s s t h e r e l e a s e f o r k o v e r t h e
release fork bolt souarelv.
- # l
{P/N 08798 -
-6El
{P/N 08798 *
RELEASE FOBK
CLUTCH HOUSING
RELEASE FoRK
RELEAS€
SETSPRING
BEARING
(P/N 08798 - 9002t
BELEASE FORK BOLT
30 N.rn {3.0 kg-m, 22 lb-ftl
f-
Install the boot, being sure that there is no clear-
ance: release fork-to-boot, and boot-to,clutch hous-
i n g ,
.Move the release fork right and left to make sure
that the release fork fits properly against the release
bearing, and that the release bearing slides smooth-
RCLEASE BEARING
RELEASE FORK
12-7