Menu Configuration - Mitsubishi Electric C80 Series Instruction Manual

C80 Series Instruction Manual
5 Setting a Tool and a Workpiece
Note
(1) If a value outside of the setting range is entered, an error occurs, and the value cannot be set.
(2) When the sorting of tool data is in progress, the operation message "Sorting of tool data is in progress" appears, and
the data cannot be set.
Refer to the figures below for the graphic and the nose position of each tool.
Lathe turning
Ball end mill
Tap
indicates the tool nose position.

5.5.3 Menu Configuration

Menus (List view)
Menus
Displays the tool management data with the designated tool management number at top.
Mng No
search
Displays the tool management data with the designated tool number at top.
Tool No
search
Sorts the tool No. in ascending order.
Tool No
sort
Clears the tool management data from the cursor line.
Tool
clear
Setting method: First data number to be cleared/last data number
(Example) 10/30: The line data of data numbers 10 to 30 is cleared.
If you press the [INPUT] key without entering the data number, data at the current cursor line is cleared.
Copies a single line of data locating at the cursor position.
Line
copy
Writes the copied data (single line data) in the cursor line.
Line
paste
Switches to the detail view of tool management data.
Disp
details
This closes the pop-up window and quits this function.
Close
Groove Thread cut
Flat end mill
Face mill
10/E: All line data that has data number 10 or less is cleared.
Lathing drill
Drill Radius end mill
Details
169
Lathing tap
Chamfer
IB-1501453-C