Setting Tool Compensation Amount (Tool Offset Screen) - Mitsubishi Electric C80 Series Instruction Manual
Hide thumbs
Also See for C80 Series:
- Manual (749 pages) ,
- Maintenance manual (162 pages) ,
- Connection and set up manual (304 pages)
Table of Contents
Advertisement
C80 Series Instruction Manual
5 Setting a Tool and a Workpiece
5.4 Setting Tool Compensation Amount (Tool Offset Screen)
Setup
Offset
Monitr
Offset
The tool compensation data can be set and displayed tool offset (T-ofs) screen of the setup (Setup) screen.
Depending on the value of the parameter "#1037 cmdtyp", there are three types of tool compensation: M system tool com-
pensation type I (cmdtyp=1), tool compensation type II (cmdtyp=2), and L system tool compensation type III (cmdtyp=3).
The tool radius compensation can be carried out using the diameter value if the parameter "#8117 OFS Diam DESIGN" is
set to ON.
The number of tool compensation sets to be designated or displayed varies depending on the specifications.
Tool compensation data can be set or displayed on the monitor (Monitr) screen.
Note
(1) When the tool compensation amount setting during automatic operation is enabled ("#11017 T-ofs set at run" = "1"), the
tool compensation amount data can be set even during automatic operation or operation pause.
IB-1501453-C
142
Advertisement
Table of Contents
