Mitsubishi Electric C80 Series Instruction Manual page 361

C80 Series Instruction Manual
9 Machining a Workpiece
Display items
Display items
(1) Path display
(2) Current edit display "Ed-
iting"
Insert mode display
(3) File name display
(4) Top line of the displayed
program
(5) Line number
Program display
(6) Input section
A selection part system operation search can be carried out using the block with the cursor as the top.
There are 2 ways to search cursor position, "INPUT search" and "Edit/search signal search".
IB-1501453-C
The path of the currently opened program file is displayed.
(If the path is too long, the portion exceeding single-byte 49 characters is not dis-
played.)
(Example) Memory: /Program
Displayed when the program is edited after it was displayed.
The overwrite mode and insert mode are switched by pressing the [INSERT] key.
During insert mode: "INS" appears.
During overwrite mode: Nothing appears.
This displays the file name of the program currently being edited.
"MDI" appears when the MDI program is edited.
The top line of the program to be displayed is displayed.
Each line of the program is numbered, and only the last three digits are displayed. If a
line is wrapped because a line is too long, no number is assigned to the top of the next
line.
This displays the contents of the program (machining program, MDI program) currently
being edited.
The line that the cursor is on is highlighted.
If the value of the parameter "#8952 Edit-win $ switch" is set to "1" and a part system
is switched while the window is displayed, the display is changed to the program of the
part system.
Machining program editing:
Switch the mode selection switch to other than "MDI mode" and press the [Edit] main
menu.
However, to edit data, designate the machining program to execute a search.
MDI program editing:
Switch the mode selection switch to "MDI mode" and press the main menu [Edit].
This displays details of the key input.
336
Details