Mitsubishi Electric C80 Series Instruction Manual page 170

C80 Series Instruction Manual
5 Setting a Tool and a Workpiece
Nose data
Set the radius (Nose R), wear radius (R-wear), and point (Point) of the nose that is mounted on the tool for each tool
used.
When a tool compensation number is designated by the tool command (T command), the nose data is offset together
with the tool length data and wear data.
CAUTION
If the tool compensation amount or workpiece coordinate system offset amount is changed during automatic oper-
ation (including during single block stop), the changes will be valid from the command in the next block or after sev-
eral subsequent blocks.
145
(1)
IB-1501453-C