Mitsubishi Electric C80 Series Instruction Manual page 247

C80 Series Instruction Manual
5 Setting a Tool and a Workpiece
CAUTION
If the tool compensation amount or workpiece coordinate system offset amount is changed during automatic oper-
ation (including during single block stop), the changes will be valid from the command in the next block or after sev-
eral subsequent blocks.
Menus
Menus
This inputs the offset amount with the absolute mode.
=Input
When "#8929 Disable=INPUT:comp" is set to "1", this menu cannot be selected.
This inputs the offset amount with the additional mode.
+Input
This sets the workpiece coordinate system offset so that the current machine coordinate becomes the
Easy
workpiece coordinate zero point.
setting
Only the axis at the cursor position is set.
When "#8935 W COORD CONFIRM" is set to "1", a operation message is displayed, and the menu is
highlighted.
This displays the G54 - G59 workpiece coordinate system offset amount. The cursor moves to the G54
G54-G59
offset. This menu can be used when the G54 - G59 offsets are not displayed.
Enter the P number displayed at the screen to display the extended workpiece coordinate (G54.1 Pn)
G54.1
offset in the coordinate system offset area. This menu is not displayed if the extended workpiece coor-
P
dinate system offset specification is disabled.
If the local coordinate system offset (G52) displays in the G92/G52 area, the display changes to G92.
This displays the G92 or G52 coordinate system offset amount. The G92 offset data is always displayed
Coord
when the cursor is not at the G54 to G59 offset data.
G92/G52
Coordinate system offset
All
All coordinate system offset amounts for all axes are erased with the exception of G92 and EXT.
clear
Coordinate system offset
All axs
This erases the local offset data for all axes corresponding to the offset data of the coordinate system
clear
where the cursor is located.
This changes the axes displayed at the coordinate system offset and measurement position counter ev-
Next
ery 5 axes.
axis
<Note>
This displays when there are 6 or more axes.
IB-1501453-C
Details
222