Mitsubishi Electric C80 Series Instruction Manual page 241

C80 Series Instruction Manual
5 Setting a Tool and a Workpiece
Display items
Display items
(1) External workpiece co-
ordinate offset
(2) Tool L offset num
(3) Wear offset num
(4) Coordinate system off-
set
(5) On mea
(6) Guide graphic
Menus
Menus
This selects the coordinate system offset which sets the measurement value when [MeasVal take in] is
Coord
executed from sub-menu (G54 - G59). The workpiece coordinate system offset data is displayed after
G54-G59
selected. However, the cursor is not displayed and the data cannot be set.
This selects the coordinate system offset which sets the measurement value when [MeasVal take in] is
Coord
executed. Input the P No. to display the selected external workpiece coordinate system (G54.1 Pn) off-
G54.1 P_
set in the coordinate system offset area. However, the cursor is not displayed and the data cannot be
set.
If the extended workpiece coordinate system offset specification is invalid, this menu is grayed out and
non-selectable.
This measures G54 - G59 and G54.1Pn. When this menu is pressed, the workpiece coordinate offset
MeasVal
data is calculated from the machine coordinate, the used tool length, the tool nose wear compensation
take in
amount and the external workpiece coordinate offset, and the data is stored in Z axis of the selected
coordinate system offset.
IB-1501453-C
This displays the external workpiece coordinate offset.
When the workpiece measurement signal is input, the measurement result is set to
2nd axis of the external workpiece coordinate.
<Note>
The 5th axis and following are not displayed.
This displays the compensation No. of tool length data used by automatic calculation.
<Note>
If an illegal value is set, the value is blank. ("0" is displayed.)
The No. is displayed by BCD code.
This displays the compensation No. of tool nose wear data used by automatic calcu-
lation.
<Note>
If an illegal value is set or tool nose wear data is not used for measurement
("#1226 aux10/bit0" is 1), the value is blank. ("0" is displayed.)
The No. is displayed by BCD code.
This displays the coordinate system offset in which the measurement result is written
when the menu [MeasVal take in] is pressed. G54 is displayed in default.
When the menu [MeasVal take in] is pressed, the measurement result is set to 2nd
axis of the external workpiece coordinate.
<Note>
The 5th axis and following are not displayed.
The display of coordinate system offset area is switched by page up/down keys.
For details, refer to "5.8.4 Changing the Coordinate System Display".
When the measurement switch is ON and the operation mode is manual mode (han-
dle, jog, rapid traverse, or step), "On mea" is displayed, and the workpiece can be
measured by the workpiece measurement signal.
This displays the measurement area.
216
Details
Details