Mitsubishi Electric C80 Series Instruction Manual page 172

C80 Series Instruction Manual
5 Setting a Tool and a Workpiece
The setting/display ranges are as follows based on the combination of "#1003 iunit" (Input setup unit) and "#1041 Initial
inch".
(Type I, Type II, Type III (data of wear, tool length, tool nose R and R wear))
#1003 iunit #1041 I_inch
B
C
D
E
When data without the decimal point is input, a set unit can be specified by the parameter "#8119 Comp. unit switch".
The standard settings and display ranges are as follows.
Type
I
II
III
(*1) It is displayed if "#8117 OFS Diam DESIGN" is "1".
(*2) It is displayed at the left of axis name if parameter "#1019 dia (Diameter command)" is set to "1".
Type II (Length wear/Radius wear) Type I
Type III (Wear data/Radius wear)
0 -999.999 to 999.999
-9999.999 to 9999.999
1 -99.9999 to 99.9999
-999.9999 to 999.9999
0 -999.9999 to 999.9999
-9999.9999 to 9999.9999
1 -99.99999 to 99.99999
-999.99999 to 999.99999
0 -999.99999 to 999.99999
-9999.99999 to 9999.99999
1 -99.999999 to 99.999999
-999.999999 to 999.999999
0 -999.999999 to 999.999999
-9999.999999 to 9999.999999
1 -99.9999999 to 99.9999999
-999.9999999 to 999.9999999
Display position
Top of display area
(*1)
Left side of radius
Left side of radius wear
(*1)
Left side of axis name
(*2)
Setting/display range
Type II
Type III (Tool length data/Nose R)
147
(Length dimension/Radius
dimension)
IB-1501453-C